Product Name: Ringfeder RfN 7013.0 Locking Assembly Product Brand: Ringfeder Product Code: RfN 7013.0 Product Artikel: Ringfeder RfN 7013.0 Locking Assembly
These Locking Assemblies are of single-taper design with a self-locking taper providing good self-centering action and concentricity, as well as increased torque capacity. A pre-centering hub section is not required. Integral push-off screws for disassembly are provided. This unit can be placed deep inside a bore due to it’s design. Available sizes: Metric series shafts from 20 mm to 150 mm dia. and Inch series for shafts from 1” to 4” diameter. Characteristics
Excellent concentricity and very easy to dismantle – these Locking Assemblies provide particularly good concentricity between the clamped parts. The flange is reinforced at the critical point. This prevents a bending and lifting of the inner ring during installation and therefore a good dismantling is ensured.
High rotation speed – the Locking Assemblies remain true-to-form during assembly and so they are suitable in applications with higher rotational speeds.
High radial loads – the material strength of the RfN 7013 Locking Assemblies makes them especially suitable for applications with high radial loads.
Example applications
crane running wheels
couplings
gearwheels
flywheels
fan wheels
Mounting of Locking Assembly
The Locking Assemblies are supplied slightly oiled and ready-to-use. The values for T, F ax , p W and p N apply to Locking Assemblies in delivery condition.
Surface finishes
For shafts and hub bores R a = 1,6 μm
Tolerances
We recommend the following mounting tolerances
Shaft: h8; Hub: H8
Change of screw tightening torques
A change of the TA-values given in the above table is not admissible.
"Ringfeder RfN 7013.0 Locking Assembly" معلومات مفصلة
يرجى الاتصال بفريق الدعم المباشر لدينا أو ملء نموذج العرض عبر الإنترنت للحصول على معلومات مفصلة عن المنتج Ringfeder - RfN 7013.0 - Ringfeder RfN 7013.0 Locking Assembly سوف نعود إليك في أقرب وقت ممكن.
