Ringfeder RfN 7013.1 Locking Assembly

Ringfeder

Ürün No: RfN 7013.1
Üretici: Ringfeder
Confirmed Rating: ☆☆☆☆☆ ☆ (3.8)
Rating Count: 11064

Ringfeder markalı, RfN 7013.1 koduna sahip Ringfeder RfN 7013.1 Locking Assembly isimli ürün hakkında detaylı bilgi almak için lütfen canlı destek ekibimiz ile hemen iletişime geçin ya da bir online teklif formu doldurun. Size en kısa sürede dönüş yapacağız.
PLEASE MAIL TO: info@industrialmaterialcenter.com

Datasheets for Ringfeder RfN 7013.1 Locking Assembly

Description for Ringfeder RfN 7013.1 Locking Assembly

These flange type units fix the hub positively against their extended flange preventing axial movement during tightening. Applied wherever self-centering action and good concentricity of mounted components are essential and hubs with straight-thru bores are used. Available sizes: Metric series shafts from 20 mm to 150 mm dia. and Inch series for shafts from 1” to 4” diameter.Characteristics Excellent concentricity and very easy to dismantle – these Locking Assemblies provide particularly good concentricity between the clamped parts. The flange is reinforced at the critical point, preventing bending or lifting of the inner ring during assembly and thereby ensuring easy dismantling. High rotation speed – the dimensional accuracy of the RfN 7013 Locking Assemblies allows their use in applications with higher rotational speeds. High radial loads – the material strength of the RfN 7013 Locking Assemblies makes them especially suitable for applications with high radial loads. Axial hub positioning – the increased outer diameter of the flange prevents the axial movement of the hub during assembly, and improves the run-out ability of the Locking Assembly. High torque – the increased number of clamping screws ensures the same transmission values as the RfN 7013.0. Mounting of Locking Assembly The Locking Assemblies are supplied slightly oiled and ready-to-use. The values for T, Fax, pW and pN apply to Locking Assemblies in delivery condition. Surface finishes For shafts and hub bores Ra = 1,6 μm Tolerances We recommend the following mounting tolerances Shaft: h8; Hub: H8 Arrangement of several Locking Assemblies RfN 7013.1 Arrangement only possible from 2 sides. If several Locking Assemblies are used to increase the transmission values the clamping systematization has to be considered. Change of screw tightening torques A change of the TA-values given in the above table is not admissible.

Latest Comments for Ringfeder RfN 7013.1 Locking Assembly

İlginizi Çekebilecek Ürünler Ringfeder