Ringfeder RfN 7015.1 Locking Assembly

Ringfeder

Ürün No: RfN 7015.1
Üretici: Ringfeder
Confirmed Rating: ☆☆☆☆☆ ☆ (3.4)
Rating Count: 2094

Ringfeder markalı, RfN 7015.1 koduna sahip Ringfeder RfN 7015.1 Locking Assembly isimli ürün hakkında detaylı bilgi almak için lütfen canlı destek ekibimiz ile hemen iletişime geçin ya da bir online teklif formu doldurun. Size en kısa sürede dönüş yapacağız.
PLEASE MAIL TO: info@industrialmaterialcenter.com

Datasheets for Ringfeder RfN 7015.1 Locking Assembly

Description for Ringfeder RfN 7015.1 Locking Assembly

This version of the RfN 7015 is designed for high bending load applications such as conveyor pulleys, by providing lower shaft and hub pressures. Available in sizes 100 to 800 mm.Characteristics Locking Assembly for transmission of torques, axial forces and high bending moments at reduced contact pressures, with special requirements to the true running of the clamped pieces. Special features - With the long and flat angle of the cones, the required loads can be transferred with one Locking Assembly RfN 7015.1. During mounting Locking Assembly, shaft and hub remain to each other in position. Compared to three-part construction types, thus an additional safety is provided. Shaft and hub are only compression loaded. Bending moment and radial loads – combined loads can be transmitted (Please contact our technical department for assistance). Excellent centering ability – with a relatively wide design and the precentering web the RfN 7015.1 Locking Assembly has excellent centering ability. Example applications: belt drums gear wheels Mounting of Locking Assembly The values for T, Fax, pW and pN apply to Locking Assemblies installed in oiled condition. Surface finishes For shafts and hub bores Ra ≤ 3,2 μm Tolerances We recommend the following mounting tolerances Shaft: h8; Hub: H8 Arrangement of several Locking Assemblies RfN 7015.0 Max. two RfN 7015.1 Locking Assemblies can be used in series, the transmissible torques and axial forces are added. Change of screw tightening torques A reduction of the contact pressures and the transmission values by reducing the tightening torque of the screws is possible. the admissible lower limit results from the multiplication of the TA values of the above table by 0,8. There is an approximate linear relationship between T, TA , Fax, pW and pN.

Latest Comments for Ringfeder RfN 7015.1 Locking Assembly

İlginizi Çekebilecek Ürünler Ringfeder